Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Section


Column

Use this yield profile to create a rate adjustment by Occupancy ONLY.

This means that a rate adjustment will be triggered by ONLY an Occupancy event. Decide As described elsewhere, decide if your will occupancy events as a way to trigger a rule,? If you do, will occupancy be based on the entire Site occupancy (ie all Rooms added together and then occupancy/vacancy analyzed by the entire inventory of the Site); else by Room Type occupancy which would apply the occupancy only to the Room Types allocated as detailed below. In a Room type Type Occupancy setting, for example, if you had 5 KING rooms and had an Occupancy rule based on 20% occupancy, then the system will only enforce that Yield Rule when 2 Kings were booked and would ignore any other Room Types when invoking the Yield Rule.  This is a key difference and a property can be setup as one or the other, not a mix of both.

For example, raise rates by 10% if occupancy is above 80% and lower rates by 10% if occupancy is below 50%. These yielded tiers can also be set to flat dollar amounts. For example, raise rates by $15 if occupancy is above 80% and lower rates by $10 if occupancy is below 50%.

Occupancy setting: Set occupancy "below" AND "above" a percentage occupancy amount to trigger the rate change. I.e. Below 50%


Column
width30%


Panel
borderColor#559ADE
bgColor#F0F0F0
titleColor#ffffff
borderWidth1
titleBGColor#559ADE
titleIn this section
Page Tree
rootYield Management




...