Use this yield profile to create a rate adjustment by Occupancy ONLY. This means that a rate adjustment will be triggered by ONLY an Occupancy event. As described elsewhere, decide if your occupancy will be based on the entire Site occupancy (ie all Rooms added together and then occupancy/vacancy analyzed by the entire inventory of the Site); else by Room Type occupancy which would apply the occupancy only to the Room Types allocated as detailed below. In a Room Type Occupancy setting, for example, if you had 5 KING rooms and had an Occupancy rule based on 20% occupancy, then the system will only enforce that Yield Rule when 2 Kings were booked and would ignore any other Room Types when invoking the Yield Rule. This is a key difference and a property can be setup as one or the other, not a mix of both. For example, raise rates by 10% if occupancy is above 80% and lower rates by 10% if occupancy is below 50%. These yielded tiers can also be set to flat dollar amounts. For example, raise rates by $15 if occupancy is above 80% and lower rates by $10 if occupancy is below 50%. Occupancy setting: Set occupancy "below" AND "above" a percentage occupancy amount to trigger the rate change. I.e. Below 50% |